Sailor C4951WP Operating And Installation Instructions - Dsc Operation In Detail
7
6
DSC operation in detail
6.1
Receiving DSC calls
When you receive a DSC call, the handset will ring (see next
section). At the same time, the Call indicator lamp will light and, if it
is a DISTRESS call, the Alarm indicator lamp will also light. In
addition, one of the following will apply.
1.
If the handset is on its rest in VHF mode
If the handset is in VHF mode, it automatically switches to DSC
mode. The display toggles with the second screen carrying
limited information on the call.
2.
If the handset is on its rest in DSC mode
If the handset is in DSC mode or with its Function menu active, it
continues as normal.
3.
If the handset is off its rest in VHF mode
If the handset is in VHF mode, it continues in VHF mode. Press
Tel/DSC to see the display carrying limited information on the
call as in 1.
4.
If the handset is off its rest in DSC mode
If the handset is in DSC mode or with its Function menu active, it
continues as normal.
In every case, to view the complete DSC message, press RX/Log
and use the right arrow to step through the information.
6.2 Differentiating calls by the ringing tone
Your VHF DSC rings in various ways according to the nature of the
call, as the following diagram shows.
30 sec.
3 sec.
1 sec.
7 sec.
DISTRESS &
URGENCY
TONE SIGNAL
35294
CONNECT
VHF
CALL
DISTRESS
SAFETY CALLS
ALL SHIP
OTHER
DSC CALLS
Restarts
after
30 sec.
The sequence of each of these repeats every 30 seconds or until the
DSC call is read or answered. If the handset is off its rest, it rings
with a short tone every 30 seconds until the call has been read.
Operation
0238