Sailor C4951WP Operating And Installation Instructions - page 16
12
6.8
Function menu
The function menu enables you to set up and check the various
functions of the handset. It also offers facilities to view and change
the functions of the VHF transceiver and of the DSC modem.
6.8.1
To enter the function menu
To set up or view items in the function menu, press Shift, Func. The
display will read TELEPHONY.
6.8.2
To move around the function menu
1.
Use the up and down arrows to locate the function – DSC,
GENERAL or SERVICE.
2.
Press the right arrow to select the function.
3.
Press and hold the left arrow for 1 second to go back to function
selection.
6.8.3
To edit items in the function menu
1.
Use the up and down arrows (a) to toggle between Y (yes) and
N (no) and (b) to change single numeric values up or down until
the limit is reached.
2.
Use the right arrow (a) to select an item and move to the next
and (b) to move a step to the right in an item with more than one
input.
3.
Use the left arrow (a) to delete the character to the left of the
cursor and (b) by holding for 1 second to go back to function
selection.
4.
Use the alphanumeric keys to enter data at the cursor position.
6.8.4
To exit the function menu
If you have changed any setting while in the function menu, you
must turn the handset off and then on again for the changes to take
effect. You can exit in one of the following ways:
1.
By pressing 16 to activate channel 16 in VHF mode.
2.
By pressing Shift, Func to activate VHF mode on the last
channel you used.
3.
By pressing Tel DSC to activate VHF mode on the last channel
you used.
4.
By pressing RX Log to enter the DSC RX log menu.
Example
To activate a keyboard beep every time a key is pressed:
1.
Enter the function menu by pressing Shift, Func. The display
will read TELEPHONY.
2.
Press the up or down arrow twice to display GENERAL.
3.
Press the right arrow to display ILLUMIN.
4.
Use the up or down arrow to locate SOUND.
5.
Press the right arrow to display EARPIECE.
6.
Press the up or down arrow twice to display KEYBOARD.
7.
Press the right arrow to display KB.BLEEP N
8.
Now use the up or down arrow to toggle the final Y (Yes) or N
(No) to select.
9.
Finally, press the right arrow to re-enter the function menu. To
activate the new setting, turn the handset off and then back on
again.
Operation
0203