Sailor C4951WP Operating And Installation Instructions - page 25
21
7.9
Installing the Control Unit
1.
With the VHF system turned off, connect the control unit- to the
system as described above.
2.
Switch the VHF system on by pressing the ON/OFF button
3.
The next step is to set up the control unit SPARC-bus location
number and SPARC-bus handset name by the following steps.
4.
Press Shift, Func to display TELEPHONY.
5.
Press down arrow to display SERVICE.
6.
Press right arrow. An asterisk will flash.
7.
Key in your access code 9876 using the alphanumeric keys. To
enter the first digit, press the appropriate key rapidly four times
to display the digit. Then pause for two seconds until the asterisk
moves to the right. Now enter the second digit by pressing four
times in quick succession. Continue until all four digits have
been entered. If you make a mistake, use the left arrow to move
backwards and cancel.
8.
Press right arrow three times, to display BUS SETUP, HANDSET
and LOC NO in turn.
9.
Use up or down arrow to change SPARC-bus location number.
10. Press right arrow.
11. Use the Func and Power keys to enter or change the name of
the handset.
12. Press right arrow to move one character to the right or select
the name already entered.
13. To finish setup, press Shift and Func. Alternatively, just press 16.
7.10 Linking an external speaker
If an external speaker is to be linked to the handset, proceed as
follows.
1.
Lift the handset.
2.
Press Shift, Func to display TELEPHONY.
3.
Press down arrow twice to display GENERAL.
4.
Press right arrow once to display ILLUMIN.
5.
Press down arrow twice to display SOUND.
6.
Press right arrow once to display EARPIECE.
7.
Press up arrow once to display LOUDSPEAK.
8.
Press right arrow three times to display EXTSPK.
9.
Use up and down arrows to display 0 for no external speaker
selected, 1 for external speaker 1, 2 for external speaker 2, or 3
for both external speakers.
10. Press right arrow to complete selection. If you make a mistake
at any step, simply press 16 to return to the beginning. It is not
possible to step backwards through the menu sequence.
ATTENTION: When more control units are connected to the VHF
system, they all have to be assigned different location numbers for
the system to function correctly. The control unit at a ship’s central
control should be assigned location number 1. Under the VHF
system, the control unit with location number 1 has the highest
priority in the system and so is able to control the system at any
time.
Installation - Control Unit
0238