Sam4s SER-7000 Quick Start Manual - Initial Startup
6
x
SER-7000 Series Quick Start Guide
SER-7000 Series Quick Start Guide
Initial Startup
1. Plug the terminal into a grounded outlet on an isolated circuit.
Clean isolated
power is essential for the proper operation of sophisticated electronic equipment.
Consult your dealer to determine if additional power conditioners are required for
your installation.
2. Turn the power on. The power on/off toggle switch is located on the right side at
the rear of the terminal. The display will light and the journal printer will advance.
3. Insert an operator key into the key lock and turn to the
REG
position.
4. Your SAM4s dealer will perform a memory all clear before beginning to program
your SER-7000/7040. This will insure that any residual program data will be
cleared before your program is installed. Refer to “Memory All Clear” in the SER-
7000/7040 Program manual. You will need an S key to perform this secure
function.
5. The default program is installed at the completion of the Memory All Clear. Each
key will be set with the function of the default key sheet. All PLUs will operate as
zero value preset keys and all functions will operate as labeled.
6. You must sign on an employee before registrations are accepted. If the message
ENTER EMPLOYEE #
displays, you can sign on a default employee by pressing
the numeric
1
and then the
EMP#
key.
Notes:
Before using this terminal for the first time, leave it powered ON in the REG mode for
at least 24 hours. This allows the Ni-Mn battery, which maintains the terminal’s
memory while the power is OFF, to fully charge.
Should it ever become necessary to replace the battery, proper disposal of the battery is
required. Refer to your local codes for disposal requirements.