Sensus PolluStat E Installation And Operating Instructions Manual - page 10
Heating / Cooling meter PolluStat E
Installation and operating instructions
M H 4110 INT PolluStat E, page 10
5.5 Control menu for tariff purposes
Each display item is marked with the letters
„CTRL“. The settings for the tariff functions can be
controlled here.
Set averaging interval for
flow rate and heating
resp. cooling power *
Heating resp. cooling
power in current
averaging interval *
Flow rate in current
averaging interval *
Setting for tarif 1
(if activated) *
Switch-over
temperature
for cooling energy *
(only for combined
heating / cooling meters)
Switch-over
temperature
difference for cooling
energy *
(only for combined
heating / cooling meters)
Return to selection menu
(depress for 2 seconds)
5.6 Parameter menu
Each display item is marked with the tool symbol.
This menu is protected by password. The
password corresponds to the last three digits of
the eight-digit serial number on the meter casing.
At first „000“ appears. Then depress the key for
ca. 2 seconds, and the left zero starts blinking. By
continuously depressing the key, the value of the
blinking digit can be changed. As soon as the
desired value is obtained, release the key. A short
keystroke confirms the set value and switches on
to the next digit. Repeat the same procedure here.
As soon as the last digit is set, the menu will be
released.
Now the desired items can be selected by short
keystrokes, the values can be set in the same way
as entering the password.
Password enquiry
Set primary M-Bus
address *
Set secondary M-Bus
address *
Set customer specific
number *
Set averaging interval for
heating resp. cooling
power and flow rate *
Set data communication
mode
(One, All, One Plus) *
Pulse
value
of
first
external meter
(0.25 to 10.000 litres per
pulse) *
Pulse
value
of
second
external meter
(0.25 to 10.000 litres per
pulse) *
Set date *
Set time *
Set target day *
Reset absolute maxima *
Reset hours of error
condition *
Reset hours with failure
of mains supply *
(only for mains supplied
meters)
Return to selection menu
(depress for 2 seconds)