Sensus PolluStat E Installation And Operating Instructions Manual - page 7
Heating / Cooling meter PolluStat E
Installation and operating instructions
M H 4110 INT PolluStat E, page 7
5. Display options
The different display options of PolluStat E are
divided into six menus. Depending on the type of
the meter and the display masking respectively,
some display items, which are marked with an
asterisk (*), can be masked. If required, the
masking can be changed via the optical data
interface of the meter with the service software
MiniCom. In the basic state the display switches
on for one second in intervals of 4 seconds and
shows the accumulated energy. By a stroke on
the red key the first display item in the user menu
(accumulated energy) is activated. The selection
menu for the other five menus can be obtained by
a pressure of 8 seconds onto the red key:
User menu
Target day menu
Archive menu
Service menu
Control menu for tariff
purposes
Parameter menu
The menus can be selected in sequence by short
strokes on the red key. As soon as the desired
menu is displayed, hold the red key for 2 seconds
in order to obtain this menu. Each one of the
single display items in the menus will be called up
one after the other by a short keystroke. If there is
no key operation within ca. 4 minutes, the display
returns automatically to the basic state. In all
menus received flow signals are shown by a
blinking symbol (left bottom display corner).
In case of meters with display illumination the light
switches on automatically with the first keystroke
and switches off automatically ca. 4 minutes after
the last keystroke.
The shown value figures are to be considered
exemplarily.
5.1 User menu
Error message
(only in case of error)
Accumulated energy
consumption
Target date energy
consumption with related
date *
Accumulated volume
Segment test
Flow sensor installation
place
(cold pipe = colder line)
Consumption tariff 1 *
(if activated)
Consumption
cooling
energy *
(only for combined
heating / cooling meters)
Consumption of first
external meter *
(optional)
Consumption of second
external meter *
(optional)
Current flow rate *
Current heating resp.
cooling power *
Temperature in warmer
line *
Temperature in colder
line *