Sentiotec wave.com4 touch Operating Instructions Manual - page 14
OPERATING INSTRUCTIONS
34/44
4.3.2
PROGRAMMING COLOUR TRANSITION PERIOD
This is the time the LED control takes on change of colour (manual or at the end of the interval
period), for the colour drift from the current to the next colour.
1. On the control element with the MODE key, go into “Automatic colour“ mode.
2. Press simultaneously for approx. 3 sec
(NB: do not change the colour number in the process!)
3. Pressing the key twice takes you into the setting menu.
4. The current colour transition time in seconds and the symbols and flash.
5. With the keys, the colour transition period is extended or shortened. Each change
of colour the occurs with this programmed time.
6. By pressing the key once, confirm the input and thus leave the programming.
4.3.3 PROGRAMMING COLOURS
The coloured lamp mixes the desired chroma from the 3 LED-base colours (Red-Green-Blue).
This mix can be programmed. This gives the customer the option of programming his personal
colours behind the colour numbers.
Range of the individual components of the colour is always 0 to 20 (5%steps)
9. On the operating element with the MODE key, go into ”Manual“ mode.
10. Press together and simultaneously for approx. 3 sec
(NB: do not change the colour number in the process!)
11. The programmed RED – portion of the chroma flashes in the display.
12. Changeable with and with the MODE key confirm the input