Sentiotec wave.com4 touch Operating Instructions Manual - page 15
13. The programmed GREEN – portion of the chroma flashes in the display.
14. Changeable with and with the MODE key confirm the input
15. The programmed BLUE – portion of the chroma flashes in the display
16. Changeable with and with the MODE key confirm the input
On completion of all inputs, the control is again in ”Manual“ mode
4.3.2. MASTER / SLAVE PROGRAMMING
Here you can set to decide whether the operating element is used in the
Single/Master operation
Selection „SIN“, (=standard setting,) without Wave.com4 sauna base section as master
Setting for pure colourLEDcontrol without sauna function
or in
Slave operation
Selection „SAU“, with sauna base section as Master
Setting for use with Wave.com4 Sauna control
5. Disconnect 4-pin bus/supply cable from the operating element
6. Simultaneous pressing of the keys
7. Plug in cable again when pressing the key.
8. The display flashes and the mode set for the operating element appears
(SIN or SAU)
5. Set the mode with the keys.
6. Confirm input with the key and jump to the ”Remote start activation“
(see 4.3.5. REMOTE START activate/ deactivate)