Springfree O92 Installation Manual - page 10
10
7
NOTE - Before proceeding, double check that each cable clip is pushed fully onto the edge of its pocket and
that there are no cable clips installed in front of any of the sensor positions.
TIP - If you are having trouble inserting the cable sensors into the sensor mounts, try flipping them over.
They are designed to only fit one way.
OUTSIDE VIEW
BOTTOM VIEW BEFORE
BOTTOM VIEW AFTER
4
2
3
1
Inside Person: Before installing the cables, note that they are different lengths and have different color labels.
Inside Person: Starting at sensor position 2, take the cable with the white tag and install the end cable sensor into
the sensor mount. Once it is in place, fasten the cable ties as shown.
Inside Person: Then, working towards sensor position 1, install the cable into each cable clip, as shown.
Inside Person: At sensor position 1, install the middle cable sensor into the sensor mount and fasten the cable ties.
If the middle cable sensor does not align with the sensor mount, double check that you have the correct cable and
that the sensor mounts are installed in the correct positions relative to the blue tags.
Inside Person: Continue installing the cable into the cable clips until you reach position B as shown above. Leave
the end of the cable hanging down towards the controller.
Inside Person: Starting at sensor position 3, take the cable with the yellow tag and repeat the above process to
sensor position 4 and then to position A. Be sure to fasten the cable ties at each sensor. At position A, the end of the
cable should be hanging down towards the controller.
INSIDE VIEW
A
B
A
B