Springfree O92 Installation Manual - page 16
16
13
NOTE - When you turn the controller on to connect to your tablet, ensure there is nobody standing/sitting
on, or leaning against, the trampoline for 15 seconds. This allows the controller to correctly set the sensors
for accuracy. This wait time should be observed each time after the trampoline is moved.
WARNING - To protect the batteries store the battery pack indoors when not in use.
NOTE - The
RED
light will begin pulsing if there is an error with the system. The error will be described
underneath Tech Info on the General Settings page of the tgoma app.
Ensure your tablet has Bluetooth turned on. Take the tablet out to your trampoline.
Install 4 AA batteries into the battery pack and place the battery pack on the controller.
Make sure nobody is on or leaning against the trampoline.
Turn on the controller by pressing the button on the front and wait for it to connect to your tablet.
The
GREEN
light should now be pulsing, indicating that the controller is running. Please wait for at least 15 seconds
to allow the system to calibrate the sensors before touching the trampoline.
Start the tgoma app on your tablet. After a few seconds the
BLUE
light should begin pulsing, indicating that the
Bluetooth connection is established.
TIP - tgoma is designed to work across a wide range of tablets. Not all versions of Android connect to
Bluetooth in the same way. Your tablet should automatically connect to a tgoma controller when you
start the tgoma app and turn the controller on. If the
BLUE
light on the controller does not light up after
approximately 30 seconds, you may need to power off the tablet and restart it. This should allow the
Bluetooth connection to be established.