Springfree O92 Installation Manual - page 12
12
9
12
Inside Person: Locate the ends of the cables that are hanging down at cable clip A and B. Cable A should be on the
left and have the yellow tag. Cable B should be on the right and have the white tag.
Inside Person: Next, locate the yellow strip along the top edge of the sensor cable tube. At the yellow strip, feed
cable A (yellow) through the top of the tube until it comes out the end.
Inside Person: Repeat with cable B (white). When the end of the cable comes out the end of the tube, plug it into
socket B on the back of the controller and tighten the collar. Then, plug the end of cable A (yellow) into socket A and
tighten.
Inside Person: Undo the Velcro® strip on the sensor cable tube, wrap it around the mat rod, and refasten, as shown.
Inside Person: Next, locate the eyelets beside the yellow strip along the top edge of the sensor cable tube. Pass a
small cable tie through an eyelet and the corresponding hole in the cable clip, as shown, then fasten. Repeat for all
three eyelets.
Inside Person: Fasten the strap at the bottom of the sensor cable tube through the back of the controller.
Inside and Outside Person: The remaining steps can be completed by just one person.
NOTE - Cable A with the yellow tag must be plugged into socket A and cable B with the white tag into
socket B. The cable plugs and controller sockets are ‘keyed’ (ie, they will only fit correctly in one position).
Line up the green post in the cable plug with the slot in the controller socket. Do not force the plug into the
socket; when you have correctly keyed them they will slide together easily.
WARNING - If there is any excess cable, loop it and tuck it back up into the sensor cable tube.
A
B
A
B
B
A
B
B
A
B
A
B
A
A
INSIDE VIEW
INSIDE VIEW
INSIDE VIEW