Springfree O92 Installation Manual - page 4
1
4
F
A
C
B
Layout all parts listed as shown.
Part Description
A
B
C
D
E
F
G
Tablet Holder Rods
Sensor Cables
Tablet Holder
Sensor Cable Tube
Locating Template
Controller
Battery Pack
1
2
1
1
1
1
1
Part Description
H
I
J
K
L
M
N
Sensor Top Plate
Sensor Mount
Cable Clips
Nut and Hex Key
Large Cable Ties
Small Cable Ties
Spare Small Cable Ties and Cable Clips
4
4
37
1
2
10
8+4
G
B
E
D
L
M
J
K
NOTE - TWO people are required for assembly.
NOTE - Installation typically takes ONE hour to complete.
H
I
LOCATING TEMPLATE
for
A
2: Outside Person
Align yellow banding on the
mat with these yellow stripes.
Re-check blue arrow alignment.
3: Outside Person
Place a sensor top plate in this hole,
prongs down.
Firmly push prongs through the gaps in
the mat material until the sensor top
plate is flat on the mat.
Remove this template.
4: Inside Person
While the outside person holds the sensor top plate firm, position a sensor
mount under the mat, flat side up.
Align the sensor mount holes with the sensor top plate prongs.
Press the two parts firmly together.
5: Inside and Outside Person
Repeat steps 1 - 4 at position 3.
Upon completion, turn this template over to position the
remaining two sensors.
The tgoma game system will not work unless you install
position two and four using side B of this template.
START
HERE
1: Outside Person
Starting at position 1 identified in the manual,
count three rods to the LEFT
(not counting the rod under the tag).
Feel for the raised bump on top of the yellow
banding on the mat where the third rod
connects to the mat rod holder under the
mat.
Place this template flat on the mat and align
the blue arrow with the center of the raised
bump.
e ma
at rod h
holder un
pl
t
te
te fl
e flat
flat on
at on
t on
at
on
h
the mat and
the mat and
the mat an
e mat and
align
align
al
ign
w
wi
it
ith
h
h th
the
he
e ce
ce
wi
nter
nter of the r
aised
ised