Springfree O92 Installation Manual - page 7
7
4
Outside Person: Locate the blue tags on the mat as shown.
Outside Person: Wipe the surface of the mat around the blue tags with a clean, dry cloth so that it is clear of debris.
Inside and Outside Person: Starting at the first blue tag position shown above, follow the steps on the locating
template to install the sensor mounts and top plates. Be sure to start on side A and find the “START HERE” icon for
the first step.
WARNING - Treat any loaded rod with caution until you are sure it is properly installed or uninstalled.
Keep your face well away from any loaded rod.
OUTSIDE VIEW
4
1
2
3
LOCATING TEMPLATE
for
A
2: Outside Person
Align yellow banding on the
mat with these yellow stripes.
Re-check blue arrow alignment.
3: Outside Person
Place a sensor top plate in this hole,
prongs down.
Firmly push prongs through the gaps in
the mat material until the sensor top
plate is flat on the mat.
Remove this template.
4: Inside Person
While the outside person holds the sensor top plate firm, position a sensor
mount under the mat, flat side up.
Align the sensor mount holes with the sensor top plate prongs.
Press the two parts firmly together.
5: Inside and Outside Person
Repeat steps 1 - 4 at position 3.
Upon completion, turn this template over to position the
remaining two sensors.
The tgoma game system will not work unless you install
position two and four using side B of this template.
START
HERE
1: Outside Person
Starting at position 1 identified in the manual,
count three rods to the LEFT
(not counting the rod under the tag).
Feel for the raised bump on top of the yellow
banding on the mat where the third rod
connects to the mat rod holder under the
mat.
Place this template flat on the mat and align
the blue arrow with the center of the raised
bump.
e
m
mat ro
od
holder u
p
p
pl
p
a
a
at
te
te
e fl
e fla
flat
at
on
on the m
at and align
w
w
w
w
w
it
it
th
h
h t
h the
center of the raised