SRLine TFT-Monitor User Manual - page 20
Page 20
SRLine monitors user manual
SR SYSTEM-ELEKTRONIK GmbH | Eschachstr. 23| D-78078 Niedereschach | phone +49 77289268-0 | info@sr-line.com
EMC
This is a class A device (industrial use). It may cause radio
interference in housing areas. In this case, the operator
might be charged to take adequate measures and be
held responsible for it.
This device serves as an installation component in an
industrial application. The operator of the entire system is
encouraged to maintain electromagnetic compatibility in
accordance with the EMC Act.
Electrostatically sensitive components
Electronic components can be damaged or destroyed by
electrostatic discharges. This doesn’t have cause a
breakdown of the module, it may also result in malfunctions!
The following directions must therefore be followed strictly:
Before working on an opened device a potenial charge of
the body has to be unloaded by touching the grounded
housing parts.
The same applies to (insulated) tools to be used, of course.
They also have to be discharged by touching a grounded
object.
If you remove or add modules from the system, the device
has to be switched off or disconnected from the power
supply every time.
You should always touch modules on the edge only.
Touching the conductors and connector pins has to be
avoided by any means.