Svantek SV 102 Quick Start Manual - page 11
SV 102 USER GUIDE
© SVANTEK
10
MAKING A SIMPLE MEASUREMENT & USING DISPLAY OPTIONS
MAKING A SIMPLE MEASUREMENT & USING DISPLAY OPTIONS
MAKING A SIMPLE MEASUREMENT & USING DISPLAY OPTIONS
MAKING A SIMPLE MEASUREMENT & USING DISPLAY OPTIONS
Press
+
push-buttons till you see main view.
If the logger function is used, make sure you have enough
free memory to save measurement results.
Press
+
to Start and to Stop a measurement.
During the measurement you cannot change the settings.
The set of results you may obtain in dosimeter mode is as
follows: DOSE (%), D_8h (%), LEPd (dB), LAV (dB),
LEQ (dB), PEAK (dB), MAX (dB), E (Pa
2
h), SEL (dB),
E_8h (Pa
2
h), SEL8 (dB), PSEL (dB), PCTC (-), PCTP (%),
RMS (dB) (for SLM the following results are available SPL,
LEQ, SEL, Lden, LEPd, Ltm3, Ltm5, Lxx, OVL, PEAK,
MAX, MIN).
You can see main measurement results by pressing right
and left
push-buttons. You can switch between
views of available measurement results (measurement
function and mode dependently: main results from left
channel, main results from right channel, 3-profiles view
from left channel, 3-profiles view from right channel,
dosimeter results, statistics for left channel, statistics for
right channel, 1/1 OCTAVE spectrum for left and for right
channel) by pressing
+
(UP) or
+
(DOWN)
push-buttons.
In 3-profiles view, active profile is changed after
pressing
.
Display
options
in
simplified
version
(for SINGLE CHANNEL mode, DOSIMETER & 1/1 OCTAVE
function) are presented below.