Svantek SV 102 Quick Start Manual - page 5
SV 102 USER GUIDE
© SVANTEK
4
This message appears when the calibrator factor stored
in TEDS memory of microphone doesn’t match calibrator
factor in the instrument’s MEMORY. It means that
the microphone hasn’t been calibrated in the channel it is
connected to or it hasn’t been used with this instrument.
The typical situation when it happens is the exchanging of
the connections of the left and right microphone.
If the TEDS or MEMORY factor is correct, select it and
press
.
If none of the value is correct, select any of them and next
calibrate the microphone, using CALIBRATION MENU
(MENU > CALIBRATION > BY MEASUREMENT) to obtain
correct factor before starting real measurements.
WARM UP TIME
WARM UP TIME
WARM UP TIME
WARM UP TIME
After power on, the instrument should be warmed up for
at least 60 seconds before starting measurement. To skip
delay, press
+
.
…