SW-Stahl S3200 Instruction manual - page 5
SW-Stahl und Werkzeugvertriebs GmbH
Tel. +49 (0) 2191 / 46438-0
www.swstahl.de
Leverkuser Straße 65
Fax +49 (0) 2191 / 46438-40
D-42897 Remscheid
E-Mail: info@swstahl.de
- 5 -
l
Do not store the machine and battery pack
in locations where the temperature may
reach or exceed 50
o
C (122
o
F).
l
Do not incinerate the battery pack even if it
is severely damaged or completely worn
out. The battery pack can explode in a fire.
l
Be careful not to drop, shake, or strike the
battery.
l
Do not charge inside a box or container of
any kind. The battery must be placed in a
well ventilated are during charging.
l
Do not dispose of battery packs into
household waste, fire or water. Battery
packs should be collected, recycled or
disposed of in an environmentally-friendly
manner. Call the authorized warranty
centers for places to dispose of damaged or
inoperable batteries.
FUNCTIONAL DESCRIPTION
This drill/driver is designed for wood/mild steel
drilling and screw driving. Please refer to the
figure on this page to familiarize yourself with
the major components of this tool before use.
1. Power Switch
Depressing the power switch partially will
energize the LED light (2) in front. Pulling
further back will start the rotation action.
When released, power to the motor will
cease and drill chuck will stop to rotate. A
small amount of sparks may appear next to
the motor. This is normal as energy is
being converted to heat for dissipation.
3. Rotation Direction Switch
Pushing this switch to the left will cause the
chuck to spin in a “forward” direction, and
“reverse” when pushed to the right.
NOTE: In the center position, this switch will
lock out the power switch.
4. Drill Chuck
The chuck will accept any bit up to be sure
the bit is fully engaged by the chuck before
operating tool. Otherwise, the bit may fly off
and cause property damage or personal
injury.
5. Non-slip Handle
The “rubberized” part of the handle gives a
more comfortable grip during operation,
shields operator from motor heat buildup, and
helps in reducing vibration and fatigue.
6. Lanyard (Shown in Fiqure1)
The lanyard is provided to help minimize the
occurrence of tool being dropped. Please use
it to your advantage and do not remove.
7. Li-ion/Ni-MH Battery
This battery provides electrical power to the
motor. Please charge it according to the
charging instruction listed in this manual.
8. Brush Access Cover
The cover allows the user to access the
carbon brush for replacement.
Figure 1