SW-Stahl S3200 Instruction manual - page 7
SW-Stahl und Werkzeugvertriebs GmbH
Tel. +49 (0) 2191 / 46438-0
www.swstahl.de
Leverkuser Straße 65
Fax +49 (0) 2191 / 46438-40
D-42897 Remscheid
E-Mail: info@swstahl.de
- 7 -
Battery Pack Life
The rechargeable batteries have a limited life. If the
operation time becomes extremely short after
recharging, replace the battery pack with a new
one.
Battery Recycling
The batteries must be recycled or disposed
properly.
Charging the battery -
for Li-ion/ Ni-MH battery
l
When charging a cool battery pack (below
0
o
C (32
o
F)) in a warm place, leave the battery
pack at the place and wait for more than one
hour to warm up the battery to the level of the
ambient temperature. Otherwise battery pack
may not be fully charged.
l
Cool down the charger when charging more than
two battery packs consecutively.
l
Do not insert your fingers/nails into contact hole,
when holding charger or any other occasions.
1. Place charger in a relatively cool and well-
ventilated area.
2. Plug charger into the AC outlet.
CAUTION: Ensure that the power source to be
utilized conforms to the power requirement
specified on the product nameplate.
3. Turn the battery up-side-down and slide the
battery into charger while keeping the alignment
marks line up. Slide the forward in the direction
of the arrow. Do not force battery as it should
slide easily into place with nominal force. Any
difficulty doing so would indicate an incorrect
alignment.
Battery Pack -
Li-ion Battery Pack
1. For Optimum battery life, store the Li-
ion battery pack following use without
charging it.
2. Do not charge battery when ambient
temperature is below 0
o
C (32
o
F) or
above 40
o
C (104
o
F). If the battery pack
is used when the battery temperature is
below 0
o
C (32
o
F), the tool may fail to
function properly.
3. This battery pack has the built-in
Battery Fuel Gauge Press the gauge
button (1) to check the fuel condition of
the battery pack.
If you notice the battery fuel gauge only
left with one red light that means the
battery is running low.
Charge the battery pack immediately, or
the power of the tool may not reach to
your desired torque.
Forward/ Reverse Rotation Switch
Operation
To prevent damage, do not press
Forward/Reverse button until the anvil
comes a complete stop.
Forward Rotation Operation
Push the button for forward rotation. After
use, set the lever to its center position.
Reverse Rotation Operation
Push the button for reverse rotation.
Check the direction of rotation before use.
After use, set the button to its center
position.