SW-Stahl S3200 Instruction manual - page 6
SW-Stahl und Werkzeugvertriebs GmbH
Tel. +49 (0) 2191 / 46438-0
www.swstahl.de
Leverkuser Straße 65
Fax +49 (0) 2191 / 46438-40
D-42897 Remscheid
E-Mail: info@swstahl.de
- 6 -
ASSEMBLY
Check for damage to the tool, parts or
accessories which may have occurred during
transport. Take the time to thoroughly read
and understand this manual prior to
operation.
This package contains:
- 1 cordless drill/driver
- 1 or 2 quick charge batteries
- 1 one-hour quick charger
- 1 power cord
- 2 combo drive bits
- 1 instruction manual
- 1 impact resistant case
Attaching or Removing Battery Pack
1. To connect battery, line up the tracks and
attach the battery pack. Slide toward the
battery pack until it locks into positions
with a click.
2. To remove the battery pack, push on the
RED button on the top and release the
battery pack.
Bit Insertion
Select proper size drill/driver bit and place in
chuck. Make sure bit is installed into the chuck
straight in and not at an angle. Hand tight chuck
in a clock-wise direction to tighten.
OPERATIONS
This product had been carefully inspected prior to
leaving the factory. It should provide you with
years of satisfying service under normal operating
conditions. Do not, however, force the tool to
perform outside its design parameters. Such
usage will void the warranty.
Note: Drilling with a dull bit will cause overheating
of the material and put un-due stress on the tool,
resulting in pre-mature failure. Be sure to use a
sharp drill bit when using this tool.
1. Slide battery into the bottom of the housing
handle until a click sound occurs. Do not force
battery as it should slide easily into place with
nominal force. Any difficulty doing so would
indicate an incorrect alignment.
2. Select a proper size drill/drive bit and insert into
the chuck. Hand tight chuck.
3. Pull back power switch slowly to engage the
LED, then pull back further to achieve desired
speed.
4. Depress the trigger switch slightly to start the
tool slowly. The speed increases with the
amount of depression of the trigger for efficient
tightening or loosening of screws.
WARNING! Always wear safety
glasses or face-shields when
operating this product. Failure to do
so can result in dust, shavings or
loose particles being thrown into
your eyes.