T&D RTR-500 Introductory Manual - Basic Procedures

12

Introduction

Basic Procedures 

The following outline shows the Basic Procedures when an 

RTR-500 Unit is being used as a Base Unit. 

 Getting Ready

1.  Get the Base Unit (RTR-500) ready to use  

2.  Install the software "RTR-500 for Windows"

3.  Install the USB Device Drivers and confirm their operation

- Checking the USB Device Driver for Base Unit and Remote Unit (RTR-574)

4.  Get Remote Units ready to use 

- For details, see the User's Manual that accompanies the Remote Unit. 

5.  Get Repeaters ready to use (only if necessary) 

 Making the RTR-500 Unit Settings (using the supplied 

software)

1.  Make Base Unit operational settings 

2.  Register Remote Units and Repeaters and make necessary 

settings 

3.  Make settings for the transmission of Current Readings, 

Warning Reports, and for the Auto-Downloading of Data

4.  Carry out transmission tests