T&D RTR-500 Introductory Manual - Compliance Information

7

Introduction

 Compliance Information

Radio, EMC and Safety Regulations

This device complies with Part 15 of the Federal Communications 

Commission (FCC) rules and with RSS-210 of the Industry Canada 

(IC). Operation is subject to the following two conditions: (1)This 

device may not cause harmful interference, and (2)this device must 

accept any interference received, including interference that may 

cause undesired operation.

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital 

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide 

reasonable protection against harmful interference in a residential installation. This 

equipment generates, uses and can radiate radio frequency energy and, if not installed 

and used in accordance with the instructions, may cause harmful interference to radio 

communications. However, there is no guarantee that interference will not occur in a 

particular installation. If this equipment does cause harmful interference to radio or televi-

sion reception, which can be determined by turning the equipment off and on, the user is 

encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is 

connected.

- Consult the dealer or an experienced radio/TV technician for help.

To comply with the limits for the Class B digital device, pursuant to Part 15 of the FCC 

Rules, this device must be installed in computer equipment certified to comply with the 

Class B limits. 

All cables used to connect the computer and peripherals must be shielded and grounded. 

Operation with non-certified computers or non-shielded cables may result in interference 

to radio or television reception.

Caution: Changes or modifications not expressly approved by the party responsible for 

compliance could void the user's authority to operate the equipment. 

Note about Antenna Usage

This device has been designed to operate with the supplied antenna only. Use of any 

other antenna is strictly prohibited.

 Important Notice

Wireless products cannot be used in countries other than where those products have 

been approved for use, according to that country's wireless regulations.

T&D Corporation shall in no manner whatsoever take responsibility for the usage of these 

products, nor be liable in any manner for legal consequences stemming from the usage of 

these wireless products in unapproved areas.