T&D RTR-500MBS-A Getting Started Manual - page 11
11
When purchasing a SIM card, you may be asked for the IMEI
number (depending on the type of SIM card).
The IMEI number for your RTR-500MBS-A can be found in the software
settings window.
1.
Install the software (see p.14 [STEP 2: Installing the Software])
2.
Connect an RTR-500MBS-A to your computer.
3.
Open the "RTR-500MBS for Windows" from the Start Screen or Start
Menu of Windows.
4.
Select “RTR-500MBS Settings Utility”.
5.
In the [Base Unit Settings] menu, the IMEI can be found under
[Version].
6.
Close the software and disconnect the RTR-500MBS-A from your
computer.
2
Setting up the Device
Connect the Antennas.
1.
Remove the protective covers from the antenna connectors (LOCAL/
CELLULAR) on the unit, and connect the supplied antennas.
If you wish to use the GPS function, connect a GPS antenna with an
SMA male plug (3V) to the GPS antenna connector on the unit.
Install a SIM Card and Batteries.
• When inserting or removing a SIM card, avoid exposure to static
electricity.
• Make sure to disconnect all cables (AC adaptor, USB cable, and external
power cable) from the RTR-500MBS-A before inserting or removing the
card.
• Be careful not to touch or scratch the IC area of the card. This may
cause poor contact.
• Make sure to insert the card in the proper direction.
• Do not force the cover open or closed.
2.
Remove the battery cover to find the SIM card holder.
Card Holder