T&D RTR-500MBS-A Getting Started Manual - page 21

21

How to Confirm Tests were Successful:

For the Transmission of Current Readings, Warning Reports, 

and Recorded Data Tests

 When the destination is T&D WebStorage Service:

Check that a “Successful” message was displayed.

 When the destination is an E-mail address:

See if the test mail has been received by the specified recipient at the set 

e-mail address.

 When the destination is an FTP server 

  (other than T&D WebStorage Service):

Check that the test data has arrived at the specified FTP Server.

For the GPS Operation Test

See if the window with the location info (latitude/longitude) has been 

displayed. 

*  To carry out the GPS operation test, it is necessary that the GPS antenna is 

properly connected to the Base Unit and then placed where it can properly 

receive a signal from a GPS satellite, such as outside, or inside by the window 

with an unobstructed view of the sky for optimal GPS performance.

*  It takes a few minutes to obtain the location data.

For the External Contact Output Test

See if the warning device connected to the external contact output operated 

properly.

If a Transmission Test Ends in Failure:

• Open [Base Unit Settings], and make sure the Mobile Data Communication info 

has been entered correctly.

• Open [FTP Settings], and make sure the information about 

T&D WebStorage Service has been entered correctly.

After checking above and making any necessary changes, if the 

transmission test still fails, click [If you have trouble, see “The transmission 

test ends in failure”.] in the [Transmission Test] menu.

 Communication Tests via PC

See the Operation Guide for details about test procedures and results.

 [Other Useful Functions] - [Checking Signal Strength (PC)]

 [Sending Current Readings] - [Making Transmission Tests]

 [Troubleshooting] - [Q&A about Settings]