TAG Heuer HL 610 Operating Instructions Manual

Summary of HL 610

  • Page 1

    1 _______________________________________ p r o f e s s i o n a l t i m i n g impulses radio transmission system hl 610 operating instructions 1. Description of the functions ....................................................................... Page 2 2. Description of the system ....................

  • Page 2

    2 1. Description of the founctions transmitter 9 8 7 5 4 6 1 receiver 9 10 5 4 3 2 2.

  • Page 3: 10.

    3 1. Description of the functions (following) 1. Input input for timing impulses (start gate, photocell – working / closing contact). Respect the polarities. 2. Outputs outputs of the timing impulses isolated by optocoupler (1 to 4 – working / closing contact). Respect the polarities. 3. Power to sw...

  • Page 4

    4 2. Description of the system low power impulses transmission system (10 mw) which doesn’t need any license (free of use) in europe (ism band – 433.56 mhz). Each receiver can receive impulses (simultaneously or not) from 4 transmitters identified by the function "channel" (1 to 4). Up to 4 teams ca...

  • Page 5

    5 3. Test and functioning principle of the system connect the antennas on the receiver and transmitters. The antennas must always be positioned vertically. Use the adapter right angle bnc if the receiver is placed horizontally. Switch on the receiver by pushing approximately 3 seconds on power. The ...

  • Page 6

    6 4. Installation of the transmitters and the receiver the hl 610 must be used in an open environment. Difficult topography (undulating country), obstacles or trees can significantly decrease the performances of the installation. It is in all the cases recommended to place the transmitters in the hi...

  • Page 7

    7 5. Battery and accumulator control transmitter press batt to check the battery power condition. Good battery: 2 « beeps » will be heard and 4 green led’s are on. Rather good battery : 2 « beeps » will be heard and 3 green led’s are on. Acceptable battery : 2 « beeps » will be heard and only 2 gree...

  • Page 8

    8 6. Technical specifications type of emission : ism band – 433.5 6mhz code : 4 differentiated channels (a, b, c, d) radiated power output : 10 mw range : superior to 2 km under optimal conditions, direct view antenna : multiflex 1/4 timing impulse inputs: open working contact. Respect the polaritie...