TAG Heuer HL 610 Operating Instructions Manual - page 5
5
3. TEST AND FUNCTIONING PRINCIPLE OF THE SYSTEM
Connect the antennas on the receiver and transmitters. The antennas must always be
positioned vertically. Use the adapter right angle BNC if the receiver is placed horizontally.
Switch ON the receiver by pushing approximately 3 seconds on POWER. The red LED is on
(see chapter 6 ).
Check the programmed "TEAM" (A, B, C or D) on the receiver and the transmitters. It must
be identical for each system. To change it, activate SET and press TEAM.
Check the programmed channel N° (CHANNEL) on each transmitter (1, 2, 3 or 4). This N°
corresponds to the OUTPUT N° of the receiver. This / or these OUTPUTS are connected to
the timing device. To modify the OUTPUT N°, activate SET and press CHANNEL.
Press TEST on the transmitter (transmission test)
- The green LED of the transmitter (1 to 4) corresponding to the selected channel N° is on
and a “beep” signal confirms the sending of the impulse.
- The green LED of the receiver corresponding to the channel N° of the transmitter (1 to 4)
is on and a “beep” signal confirms the reception of the impulse which is provided on the
corresponding output (1 to 4) to the timing device.
- The 4 green LED’s on the receiver unit allows you to monitor the quality of the signals being
received.
1 led is on
- > Very weak Signal
2 led’s are on
- > Weak Signal
3 led’s are on
- > Signal satisfactory
4 led’s are on - > Good Signal
(see chapter 2. “Description of the system HL 610”)
At the end of the test or use of the system, do not forget to switch off the receiver !
Activate SET and press POWER