TAG Heuer HL 610 Operating Instructions Manual - page 7
7
5. BATTERY AND ACCUMULATOR CONTROL
TRANSMITTER
Press BATT to check the battery power condition.
Good battery:
2 « BEEPS » will be heard and 4 green LED’s are on.
Rather good battery : 2 « BEEPS » will be heard and 3 green LED’s are on.
Acceptable battery : 2 « BEEPS » will be heard and only 2 green LED’s are on.
It is possible by huge cold (-10°C/ -15°C) to find this situation. The power of the Battery decreases
and can make believe that this one is out of use.
Bad battery :
3 « BEEPS » will be heard and only 1 green LED is on. You must replace
the battery, a normal use is no more guaranteed.
Discharged battery: 3 « BEEPS » will be heard and no green LED is on. The system is out of
use.
ATTENTION !
If the battery of the transmitter is out of order or defective, we recommend to contact
your local TAG Heuer Timing Agent. At the same time, you will have the opportunity
to control the accumulators of the receiver.
RECEIVER
When the receiver is switched on, the control of the accumulators conditions is ensured by the red
LED POWER.
Accu charged :
The red LED is on.
Accu slightly
discharged :
The red LED flashes each second.
Accu discharged : The red LED flashes very fast (more than 1 per second) The good
functioning of the system is no more guaranteed.
To recharge the receiver, use the original charger AC/DC provided by TAG Heuer. The use of
another charger can seriously damage or destroy the device.
-
Switch off the receiver to recharge the accumulators (POWER OFF).
-
Connect the charger to a normal household ac current receptacle.
-
Connect the jack of the Charger to the receiver.
-
The red LED POWER flashes during the charging.
-
10 hours can be required to fully recharge the receiver if this one was totally discharged.
Remark :
It is possible to use the charger during the timekeeping with the receiver switched on.
However, no particular message will be given by the LED POWER.