TAG Heuer HL 610 Operating Instructions Manual - 10.
3
1. DESCRIPTION OF THE FUNCTIONS (Following)
1.
INPUT
Input for timing impulses (Start gate, photocell – working / closing contact).
Respect the polarities.
2.
OUTPUTS
Outputs of the timing impulses isolated by optocoupler (1 to 4 – working /
closing contact). Respect the polarities.
3.
POWER
To switch on of the receiver (press during 3 seconds on POWER). The red
LED is on. To switch off the receiver, activate SET and press POWER.
4.
SET
To program the TEAM (A, B, C, D) or CHANNEL (1, 2, 3, 4) and to switch off
the receiver. Maintain SET pressed during the changes.
5.
TEAM
To check the programmed TEAM. The green LED corresponding to the code A,
B, C or D is on. To change the code, activate SET and press TEAM.
6.
CHANNEL To check the programmed CHANNEL. The green LED corresponding to the
CHANNEL 1, 2, 3 or 4 is on. To change the CHANNEL, activate SET and press
CHANNEL.
7.
TEST
To test the impulses transmission.
8.
BATT
To check the state of the battery.
9.
LEDS
Control LED of the programmed TEAM or CHANNEL. Allows to visualize the
transmitted impulses by the transmitter or received by the receiver.
.
10.
LEDS
LED to monitor the signal quality of the received impulses / or possible
interferences created by other radio signals.