TAG MCLAREN AUDIO CDT20R Owner's Manual - page 10
You can change the way your CDT20R displays information.
The controls for this are only on the remote control.
Press the time button repeatedly, or press and hold, to cycle
through the time display modes.
1 - The display shows the amount of time played so far on the
current track. The word TIME is also displayed.
2 - The display shows the amount of time remaining on the
current track. The words TIME REM are also displayed.
3 - The display shows the amount of time remaining on the CD.
The words TOTAL TIME REM are also displayed.
4 - The display shows the amount of time played so far on the
CD. The words TOTAL TIME are also displayed.
While a CD is playing, you can display the table of contents by
holding down the toc button. This consists of the total number of
tracks and playing time of the CD.
Press the display button to switch the display off and on.
Programming allows you to play tracks in the sequence you
choose instead of the order in which they appear on the CD.
To do this, you have to enter your chosen sequence of tracks into
the memory of the CDT20R. When you store a program, you
assign a track to each step of the program. This process is called
programming and the sequence of steps is the program.
This section describes how to store and play a program. All the
buttons referred to can be found on both the front panel and the
remote control.
In order to store and play a program, your CDT20R has to be in
program mode. In program mode, the CDT20R plays in step
sequence instead of the recorded track sequence.
To enter program mode, press the stop button for at least two
seconds. The display will show:
PROGRAM
TRACK with the track number above it
STEP with the step number below it
TOTAL TIME with the time above it
entering
program mode
time display
table of
contents
display
display off
18
19
display options
programming
stop
hold for at least
two seconds
GRA00046.1-[CA]CDT20R 13/03/01 09:53 Page 19