TAG MCLAREN AUDIO CDT20R Owner's Manual - page 13
Go to the step where you want to insert a new track. Press the
open/close button for less than two seconds
(1)
. A dash is
displayed above TRACK. You can now select a track which will
be stored at this step. The step numbers after the newly inserted
track are increased by one.
Go to the step you want to erase. Press the open/close button
twice to erase the step. The step numbers after the erased step
are reduced by one.
To erase your chosen step and all steps to the end of the
program, press the open/close button then the pause button.
If you want to erase the whole program, go to the first step, press
the open/close button then the pause button.
24
25
editing stored program
digital output types
inserting a step
erasing program
steps
coaxial output
Your CDT20R has two types of digital output
(1)
: AES/EBU and
coaxial SPDIF. If you have a choice of inputs to your digital to
analogue converter we recommend that you use the coaxial
SPDIF via a BNC connector, followed in preference by the
AES/EBU connection, then the coaxial SPDIF via a phono
connector
(2)
. All the outputs are on the back of your CDT20R.
Please ask your retailer for advice on selecting the best output
format.
Always use high-quality digital cables for connecting outputs.
The coaxial outputs conform to the SPDIF format and are intended
to be used with 75
Ω
cable. Two independent coaxial outputs are
provided. COAXIAL OUTPUT 1 has a phono socket while
COAXIAL OUTPUT 2 has a BNC socket.
pause
open/close
open/close
spdif 75 ohm
1
C O A X I A L O U T P U T
2
1. The digital signal carries both stereo channels, so only one connection is needed
2. BNC connectors give better performance than phono connectors in this
application. The phono connection is provided for convenience
1. If you hold the open/close button for two seconds or more you will lose your
whole program
GRA00046.1-[CA]CDT20R 13/03/01 09:54 Page 25