TAG MCLAREN AUDIO CDT20R Owner's Manual - page 12
time display
table of
contents
When the CDT20R is playing a CD in program mode, TOTAL
TIME and TOTAL TIME REM refer to the stored program.
When the CDT20R is playing a CD in program mode, pressing
the toc button on the remote control displays the table of contents
of the stored program.
While the program is being stored, pressing the toc button
displays the table of contents of the whole CD.
22
23
programming
editing stored program
reviewing your
stored program
changing a
selection
You can change your stored program at any time. To do this, the
CDT20R has to be in program mode. If you are not in program
mode, press the stop button for at least two seconds.
The buttons for editing can be found on both the front panel and
the remote control, except for index + and index – which are
only on the remote control.
Press the stop button then use the play or index + buttons to step
forward or the index – button to step back through your program.
Pressing the stop button always returns you to the first step.
Go to the step you want to change as if you were reviewing your
program. When you find the step, you can select a different track
by pressing the track + or track – buttons
(1)
.
1. You can also use the number buttons on the remote control
stop
hold for at least
two seconds
+
index
-
GRA00046.1-[CA]CDT20R 13/03/01 09:54 Page 23