Tait T2009 User Manual - T2000 Radio
Installation
11
1. Fit a M4 washer on each of the mounting studs inside the
radio cabinet.
2. Fit the metal cover plate onto the mounting studs. The
end of the cover plate that overhangs the plastic side
mouldings must face towards the rear of the supply.
3. Fit and fasten the 8-32 nuts onto the protruding studs.
Reassembly: Replace the cradle lid
1. Place the cradle on the mounted cover plate, taking care
to position the plastic ribs over their mating slots. They
will not fit if the cradle is back to front.
2. Clip the ribs into their mating slots. This will require
gentle pressure, with your index fingers on the inside, and
thumbs on the outside.
Reassembly: Mount the radio cabinet and
T2000 radio
1. Position the radio cabinet over the power supply so that
the mounting holes in the radio cabinet line up with the
corresponding holes in the power supply.
2. Insert the screws and then tighten all four screws firmly.
3. Slide the radio, rear end first, into the front of the cradle
until it seats firmly.
cradle outer cover
radio cabinet
cradle metal plate