Tait T2009 User Manual - Note:
Installation
13
microphone clip’s bottom mounting screw with the
supplied M4 nut and shakeproof washer. To fasten it
externally, use the microphone clip’s bottom mounting
screw.
Connect the power supply to the radio
Note:
The red and black wire of the power cable is positive.
1. Make sure that the radio and the T2009 are both turned
off and unplug the T2009 from the mains supply outlet.
2. Connect the power cable’s positive (red) wire to the posi-
tive terminal and connect the negative (black) wire to the
negative terminal on the back of the T2009.
3. Plug the power cable into the power socket on the back
of the radio.
To complete the installation
1. If an external speaker is required, connect it as described
in the installation documentation for the speaker.
2. Make sure that the radio is switched off, as described in
the user documentation for the radio.
3. Plug the power supply into the mains supply outlet and
switch it on.
T2000 power connector
speaker connector
ground strap
supply wires