Tandberg Data DLT-V4 Quick Start Manual - page 2
2
2 For SCSI — Connect an active LVD/SE terminator onto one
end of the SCSI cable, if the tape drive is the last or only
device on the SCSI bus. See
figure 2
. If the SCSI cable that
came with the SCSI host bus adapter already has a
terminator built into it, do not use an additional terminator.
3 For SCSI — Connect the SCSI cable to the tape drive and to
the SCSI host bus adapter. Connect the power cable to the
tape drive. See
figure 3
.
4 For SATA — Connect one end of the SATA data cable to the
tape drive and the other end of the SATA data cable to the
SATA host bus adapter. Connect
either
the SATA power
cable
or
drive power cable to the tape drive. See
figure 3
.
N
OTE
: If the tape drive is not the last or only device on
the SCSI bus, make sure the last device on the SCSI
bus is properly terminated
and
is powered on
whenever you use the tape drive.
C
AUTION
: Connect only one power cable to the drive;
connecting both the SATA power cable
and
drive
power cable to the tape drive may damage the drive.
Figure 3 Connect the Cables
and Secure the Cover
Drive power
cable
SCSI cable
(with terminator)
SATA power
SATA
SATA Tape Drive — Rear
SCSI Tape Drive — Rear
Drive power
cable
cable
or
data cable
5 Secure the tape drive in the selected server or workstation
with the appropriate mounting screws. See
figure 3
.
Contact the computer manufacturer if the server or
workstation uses mounting rails for internal tape drives.
6 Install the cover on the server or workstation. Connect the
power cables to any attached peripheral devices.
7 Power on any attached peripheral devices.
8 Power on the server or workstation and allow its operating
system to start.
Tabletop Tape Drive
0
Inspect and Prepare the Tape
Drive
0
1 Inspect the shipping box and contents of the box for
damage. If you find any damage, report it to the shipping
company.
2 Change the SCSI ID for the tape drive, if necessary. See
figure 4
. Use a small screwdriver or ballpoint pen to press
the buttons above or below the SCSI ID to increase or
decrease the number. For complete instructions, see the
DLT-V4 Product Manual
.
N
OTE
: Turn to the last page for information on
additional resources.
N
OTE
: Save the packing materials in case you need to
move or ship the tape drive. You must ship the tape
drive in the original or equivalent packing materials
to preserve your warranty.
DLT-V4 Tape Drive Quick Start Card