Tandberg Data DLT-V4 Quick Start Manual - page 3
3
Figure 4 Set the SCSI ID and
Connect the Cables
SCSI host
adapter
SCSI
cable
Terminator
On
Off
SCSI
cable
Power
cable
3 Select a location near the server or workstation that will
host the tape drive. Shut down and power off the host and
all peripheral devices attached to the selected host. If
necessary, install an LVD/SE host bus adapter in the server
or workstation.
Connect the Tape Drive
0
1 Connect the SCSI cable to the tape drive and to the SCSI
host bus adapter — or to the previous device on the SCSI
bus. See
figure 4
.
2 Connect an active LVD/SE terminator onto one end of the
tape drive, if it is the last or only device on the SCSI bus.
See
figure 4
.
3 Ensure that the power switch on the rear panel of the tape
drive is in the OFF position. See
figure 4
. Connect the
power cable to the tape drive and plug the power cable in
to the nearest power outlet.
4 Connect the power cables to the host server or workstation
and all peripheral devices.
5 Power on the tape drive and any attached peripheral
devices.
6 Power on the server or workstation and allow its operating
system to start.
N
OTE
: If the tape drive is not the last or only device on
the SCSI bus, make sure the last device on the SCSI
bus is properly terminated
and
is powered on
whenever you use the tape drive.
N
OTE
: Turn to the last page of this document for
information on additional resources.
DLT-V4 Tape Drive Quick Start Card