TANDBERG FieldView User Manual - page 19
15
TANDBERG
FieldView Device User Guide
D14041.02 January 2008
6. Menus
The FieldView Device has a menu system that allows Operators to check and
update system settings, view status, access the directory or sign out from the
FieldView Device.
Note that system configuration and other setup tasks are usually performed
by your site administrator and are described in the System Administration
manual.
To display the Main Menu, start from the default viewfinder display, and press
the
Display
button three times.
You can display the menus at any time, even while streaming media to a Client
user. The person on the receiving end will not see the menus.
6.1. Stream Setup
To check or change streaming setup options:
1. Starting from the default Viewfinder display, press the
Display
button three
times to display the Main Menu.
2. From the Main Menu, tap
Stream Setup
to display the streaming
options. Three preset configurations are available (defined by your site
administrator).
3. To select a built-in configuration, tap
Low Bandwidth
,
Medium
Bandwidth
or
High Bandwidth
, and then select
Accept
.
4. To set up a custom configuration, tap
Custom
and then select
Next >
to
display the Custom Stream Configuration window. This allows an Operator
to configure the stream parameters for circumstances where the predefined
settings are not adequate.
Note:
The
Video Size
and
Frame Rate
choices change depending on
whether the FieldView Device contains an NTSC or PAL camera.
5. Select your configuration options, and then select
Accept
.
Note:
The stream quality can also be selected by the FieldView Application
operator.
Main Menu on the FieldView Device.
Configuring Custom stream options.
Select a preset option, or select Custom to
configure a custom stream.