TANDBERG FieldView User Manual - page 8
4
TANDBERG
FieldView Device User Guide
D14041.02 January 2008
2. FieldView Device Basic Operation
2.1. Charging the Battery
New batteries should be charged prior to first use. To do this, plug in the
external power adapter and allow the battery to charge until the orange
battery indicator extinguishes (up to eight hours). The internal battery charger
will shut itself off to prevent overcharging once the battery is fully charged.
Note that the FieldView Device shuts itself off when battery power is low.
•
If the unit is on, and an Operator is using it in an active call, a warning
message appears so that the Operator has time to plug the FieldView Device
in to the external power adapter, or end the call before the FieldView Device
shuts off.
•
If the unit is in Standby, it simply shuts itself off.
•
If the unit is off, it cannot be started when the battery is low.
To check current battery levels, press the
Display
button once and check the
Session information at the bottom of the Viewfinder. See page 14 for more
information on Viewfinder and Display modes.
2.2. Inserting or Replacing the Battery
Important:
Before using this device for the first time you must install and
charge the battery. Here’s how (refer to figures at right):
1. Open the battery compartment and insert the battery until it clicks into
place and is flush. It only fits one way.
2. Close the battery door as follows:
•
Ensure the lock switch is in the Un-locked position.
•
Orient the battery door so it is flat against the battery well, but with a
3mm gap (as shown in the lower figure).
•
Slide the door toward the center of the FieldView Device until it is fully
closed.
•
Slide the lock switch to the Locked position.
3. Connect the FieldView Device to the external power adapter and charge the
battery until the orange LED turns off (up to 8 hours).
Note:
The device
will not
operate on the external adapter alone. You must
have a battery installed.
Gap
Figure 3
Figure 1
Locked
Un-locked
Figure 2