TANDBERG MXP User Manual - page 17
D14034.04—MAY 2008
17
MXP Video endpoints
User Guide
Making calls
Switching between video and
telephone calls
Before you make a video or telephone call, make
sure the system call type is set up accordingly.
What type of calls the system has been set up to
right now is indicated by a little icon to the left of
the Call Settings field:
This icon shows that video calls
are expected to be made.
This icon shows that telephone
calls are expected to be made.
In order to change the setting, you must navigate
to the icon:
Once there, press the OK key on the remote
control to display the submenu:
Since the system in this example was set up for
video calls, you must navigate down to Telephone
call to change it, and press the OK key to put
your change into effect.
Repeat the principle to select the other setting.
Making calls by dialing the number
Your TANDBERG system can make both video
calls and telephone calls. Telephone calls over IP
may require additional hardware and infrastructure.
If in doubt contact your administrator or your
TANDBERG representative.
Using the number keys in text fields
Whenever text entries are expected by the system,
a small abc or ABC appears in the lower right
corner of the entry field. For entry fields expecting
numbers, 123 will appear instead. In text mode,
entries from the number keys are automatically
interpreted as text entries in the same way as on a
mobile phone.
Guidelines:
Press the key that corresponds to the required
•
letter as many times as needed to produce that
letter.
Switch between lower case (
•
abc) and upper
case (ABC) letters with the # a/A key.
Switch between text mode (
•
abc) and
number mode (123) by keeping the # a/A key
depressed for more than a second.
To insert space, press the
•
0 _ key.
To insert the
•
@ sign, press the 1-key twice,
while the keypad is in text mode.
To insert the
•
. sign, press the * .-key once, while
the keypad is in number mode.
To write digits and numbers in a text input field,
•
repeatedly press the corresponding key until the
digit appears.
To make a call dialing the number…
… or select
the Call icon of
the main menu
before you press
OK key.
The Call menu is then displayed…
Enter the “number” here
(it may consist of digits
as well as letters) using
the remote control.
… start by
pressing the
green Call key
on the remote
control…
Once you have finished entering the number, start calling by: …
… pressing the
green Call key
on the remote
control…
55987602
… or by navigating
down to the green
Call icon and pressing
the OK key.
Instead of navigating down to
the Call icon, you may also just
press the OK key twice to start
calling.