Tascam CC-222MK Owner's Manual - 4- Disc Operations
1
TASCAM CC-222MKIII
Repeat playback
The unit can repeat the whole of the disc, the current
track only, or an A–B portion set as described here.
Selecting the repeat mode is only possible using the
remote control unit.
NOTE
You can use this mode with Single, Random, or
Program playback modes.
1 Theunitshouldbeinplayback,standbyorstop
mode.
Pressthe
REPEAT
keysothatthedisplayshows
Repeat ON
(the
RePeATindicatorlights).
To cancel repeat mode, press the
REPEAT
key again so
that the display shows
Repeat OFF
and the
RePeAT indi-
cator goes out.
A to B repeat playback
You can set the points between which playback should
loop.
1 Whileplayingback,pressthe
A-B
keyonthe
remotecontrolatthepointwheretheloopisto
start(A-point).
The
RePeATindicatorlightsupandA-bindicator
blinkstillthesecondpoint(B-point)isentered.
2 Pressthe
A-B
keyagainatthepointwherethe
loopistoend(B-point).
NOTE
If the A and B points are too close together, A-B
looping is not possible.
Playbackjumpsbacktothefirst“A-point”and
continuestothesecond“B-point”andthenre-
turnstothe“A-point”again,repeatingtheloop.
Cancel the A-B repeat mode by pressing the
A-B
key, or
the
STOP
key. Both indicators will go out.
During playback, if the
A-B
key is pressed, the loop
will be canceled and playback will continue past the
B-point.
NOTE
A-B repeat cannot be set when the specified sec-
tion spans more than one track, and cannot be
used with MP3 discs.
Intro check
You can skip through the first 10 seconds of all the
tracks on a CD to check the contents of the CD.
NOTE
This function is only available from the remote con-
trol unit.
1 Whenstopped,intheContinuous(normal)mode,
pressthe
INTRO CHECK
key.
Thefirst10secondsofeachtrackonthediscwill
beplayedback.
2 Pressthe
INTRO CHECK
keyagainorthe
STOP
keytostopthisplaybackprocess.
NOTE
In Single or Random playback modes, with the
disc stopped, pressing the
INTRO CHECK key can-
cels the mode and returns to Continuous playback
mode.
This function inserts a gap of about four seconds
between tracks on playback. This can be useful when
recording to tape, so that automatic searching can take
place more easily on tapes recorded from disc (see
“Search keys” on page 32).
NOTE
This function is only possible using the remote con-
trol unit.
Press the
AUTO SPACE
key when in playback, standby,
or stop mode, the
A.sPAce indicator lights on the right
side of the display. Pressing the
AUTO SPACE
key
again cancels the mode and returns to normal playback.
The
STOP
key also cancels the mode and stops play-
back.
Auto spacing