Taurus 24VACH Instruction Manual - page 12
12
After Sales Support TEL: 1800 909 909 EMAIL: info@globalpowerbrands.com
MODEL: 24VACH PLU: 44624 03/2015
After Sales Support TEL: 1800 909 909 EMAIL: info@globalpowerbrands.com
MODEL: 24VACH PLU: 44624 03/2015
Important information – Product care
This drill/driver uses Lithium Ion Battery Cells. Care
MUST be taken to ensure both the safety and life of the
pack is maintained. Ensure you have read all of the safety
notes in the previous pages before using the drill/driver.
Treat the battery pack with care and within the guidelines
of this manual. If the pack does become immersed in water
or any fluids, or is subject to a severe drop or it does not
operate within the guidelines of this manual, immediately
STOP using the battery pack and have it checked.
During operation avoid overloading the drill/driver. If the drill/
driver is overloaded it will automatically STOP. Overloading
may occur for a number of reasons including when the
drill/driver is pushed too hard or when using a drill/driver
bit or attachment greater than what is specified. If you
do overload the drill/driver during operation refer to the
“Overload” section in this manual.
Note: When the battery of the drill/driver is at the lower end of
the charge, the drill/driver is more susceptible to the overload
condition.
Running the drill/driver at close to maximum load, or
continual resetting of the overload will cause the battery
pack to overheat. When a preset cell temperature is
detected, the battery pack will automatically STOP operating
and will not restart until the battery pack has cooled to a
safe level.
In this condition, DO NOT force cool the pack by placing in
a freezer or similar device. Refer to the “Overload” section
in this manual.
Another feature of the drill/driver/battery pack is the low
voltage cut out feature. This feature operates when the
voltage drops below a preset value. When this occurs the
tool will automatically stop operating. To correct the situation
you need to either insert another charged battery into the
drill/driver or recharge the existing battery, and then proceed
with the drill/drivering/driving application.
Note: Attempting to restart the tool in this condition without
either recharging the battery or installing a battery with
charge will lead to drill/driver restarting and then stopping
again after only a few seconds of operation.
These safety devices have been fitted for the safety,
reliability and life of the tool.
Fitting and removing
the battery pack
1. To install the battery pack to
the tool, align the raised portion
of the battery pack (6) with the
grooves on the bottom of the
drill/driver, and slide it firmly
into the handle until you hear
the battery release button snap
into place. (Fig A)
2. To remove the battery pack
from the tool, press the battery
pack release button (7) and
slide the battery pack comp
letely out of tool handle. (Fig B)
When inserting the battery pack
into the charger, make sure the
pack is fully seated in the charger.
To remove the battery pack from
the charger base, press the battery
release button and slide the battery out.
A
B
24VACH IM ED13 T2.indd 12
25/11/14 5:16:49 PM