Taurus 24VACH Instruction Manual - page 16
16
After Sales Support TEL: 1800 909 909 EMAIL: info@globalpowerbrands.com
MODEL: 24VACH PLU: 44624 03/2015
After Sales Support TEL: 1800 909 909 EMAIL: info@globalpowerbrands.com
MODEL: 24VACH PLU: 44624 03/2015
Drill/drivering
Drill/drivering metals
•
Always clamp sheet metal.
•
Support thin metal with a block of wood to avoid
distorting it.
•
Use a punch to mark the centre of the hole.
•
Use a suitable lubricant for the material you are
working on,
USE:
FOR:
Oil
Steel
Turpentine or paraffin
Aluminium
Do not lubricate
Brass, copper or cast iron
Drill/drivering plastics and plastic coated chipboard
•
Use high speed drill/driver bits
•
See drill/drivering wood below
Drill/drivering masonry
•
This drill/driver is NOT designed for drill/drivering
masonry.
Drill/drivering wood
•
Clamp a piece of scrap wood to the back of your work to
prevent splintering.
All drill/drivering operations
•
Mark off the centre of the hole using a centre punch or nail.
•
Don’t force the drill/driver, let it work at its own pace
•
Keep the drill/driver bit sharp.
•
Reduce pressure, as the drill/driver is about to break
through the item being drill/drivered.
LED work light
When the unit is switched on, the LED work light (10) also
comes on to ensure better vision and to make working in
dark areas more safe. The working light goes out when the
On/Off switch (9) is released.
CAUTION! LED is laser class 1! Do not look directly into the
laser as this may result in damage to the eyes.
Chuck replacement
The chucks of reversible drill/drivers are always fixed by a
screw with a left-hand thread. The screw, which is located in
the centre of the chuck, must be removed before the chuck
can be removed. To remove the screw, turn it in a clockwise
direction. The chuck can now be removed by unscrewing it
anti-clockwise. If you have trouble removing the chuck take
the drill/driver to your nearest authorised service centre for
chuck replacement.
CAUTION. Always ensure that the drill/driver is switched
off and the battery pack is removed before making any
adjustments.
Belt clip
The belt clip (5) is used to assist
to clip the tool to your waist belt
while working. Install the clip to
the drill/driver by locating the belt
clip tabs in the slots in the drill/
driver and tighten the screw to fix
the clip firmly. (Fig I)
I
24VACH IM ED13 T2.indd 16
25/11/14 5:16:51 PM