Taurus 24VACH Instruction Manual - page 17
After Sales Support TEL: 1800 909 909 EMAIL: info@globalpowerbrands.com
MODEL: 24VACH PLU: 44624 03/2015
17
After Sales Support TEL: 1800 909 909 EMAIL: info@globalpowerbrands.com
MODEL: 24VACH PLU: 44624 03/2015
FAQ/Troubleshooting
Do I need to charge the battery before use?
Yes, New battery packs are shipped in a low charge
condition and must be fully charged before use. It takes
approximately 1 hour to fully charge your new battery.
Charging of batteries should not be undertaken casually.
Through the charging cycle the condition of the battery pack
should be monitored and the charge cycle turned off at
completion or at the end of the recommended time.
How do I obtain the best life for the battery?
- Never allow the drill to come to a complete stand still
before recharging. The battery should be placed on charge
whenever the battery is noticeably running down or the drill
no longer performs a task it previously performed.
- Avoid allowing lose items like screws or nails etc. to be
stored with battery packs as these or similar items can
short battery packs and cause a fire or explosion.
- Always unplug the plug pack charger when not in use and
store in a dry secure place.
- Avoid charging or storing your battery in temperatures
below 0ºC and above 40ºC.
How do I use the 2 gears on the drill?
To select the LOW gear (low speed, high torque setting),
push the gear selector backward, towards the back of the
drill/driver. The word LO will be displayed.
To select the HIGH gear (high speed, low torque setting),
push the gear selector forward, towards the chuck. The
word HI will be displayed.
How do I adjust the torque?
To adjust the torque setting you rotate the torque collar. The
higher the number, the higher the torque setting collar.
Controlling the torque allows for better control when using
the drill/driver on specific add screwing tasks and prevents
over-fastening and over-tightening.
For drill/driving, always use the drill/driver position by
aligning the drill/driver symbol with the triangular indicator
on the front face of the drill/driver near the torque collar.
For setting the torque position, select a low setting on
the torque collar and align the selected symbol with the
triangular indicator on the top of the drill/driver.
What is the function of the Forward / Reverse switch?
This switch will allow you to change the direction of the
motor while the trigger switch is not depressed.
Drill/driving uses the forward mode. The reverse mode is
intended for the removal of screws and assisting to remove
jammed drill/driver bits.
What do I do if I have an issue with my drill?
If you have any issues with your drill/driver, please contact
our Customer Service line on 1800 909 909.
24VACH IM ED13 T2.indd 17
25/11/14 5:16:51 PM