Taurus TTA-11241 Instruction Manual - page 20
Maintenance
Remove the plug from the socket
before
carrying
out
any
a
d
ju
s
tm
en
t
,
servicing or
m
a
inten
a
n
c
e
.
IF
the supply
cord is damaged,
it must be replaced
by
a special cord or assembly
available
from
the
manufacturer or its service
a
ge
n
t
.
Replacing Sanding Belt:
•
Pull the b
elt tension lever
(7)
from
l
eft
to
right to release the belt tension
·
(Fig.
19A).
•
Loosen and remove the screws on the.
upper sanding drum guard (Fig.
198).
•
Loosen and remove the
two
screws
unde
r
the
upper sanding drum guard
(n) (Fig.
19C).
•
Loosen and
remove the four screws
on the bel
t
side cover (Fig.
1
90).
•
Remove
t
h
e lower belt cover.
•
Pull out the old belt and replace a
new one.
Note:
•
The sanding belt must run in the
direction of the arrow
(p)
on the
smooth side of the belt .
•
Ensure the sanding belt is centered
on the drum.
•
Install the lower belt cover
(0) a
nd the
upper sanding drum guard
(3)
in
reverse procedure.
•
Push the belt tension lever
(7) back
into place.
Note:
The belt tension lever
(7)
is
spring-loaded so use extreme caution
when pushing it into place
.
After Sales SupportTel: 1300-355-255
'
18