TCC Kitchen Center Installation Manual - page 4
The Mini Chopper
The Mini Chopper is made for convenience;
its lightweight polymer design is ideal for clear
visual dicing and chopping. It makes short work
of seasoned breadcrumbs, salsa, onions or pâté.
The separate protective base lets you stand the
mini-chopper on your counter top.
To assemble your mini-chopper:
1. Slot the three pins on the power post into the
matching indentations in the bottom of the jar.
2. Secure the locking cap to the top of the power
post by turning clockwise until it clicks.
3. Drop the blade assembly into place over the
power post.
4. Lock the lid into place on the jar with a “push
and turn” clockwise motion to engage the blades.
The blades are very sharp, handle with extreme
care
2
11
Introduction
The Mini Chopper attachment has been approved for indoor use
Congratulations on your purchase of a Kitchen Center. Before you try it out, take
outdoors
only. Do not operate the Mini Chopper with the Power Base
a few moments to read this Owners Manual and familiarize yourself with the
easy, convenient functioning of the power base and attachments.
IMPORTANT SAFEGUARDS
It is important to understand and observe the safety warnings and cautions in this
section and throughout the manual. If you do not have installation and electrical
experience, we suggest that you employ a professional installer to ensure that
the work is performed in accordance with required safety code.
Before using the Kitchen Center, read all the instructions and be sure to follow
the basic safety precautions listed below:
•
The Kitchen Center Power Base and attachments are for household use only
•
Never leave an appliance running un-supervised
•
Close supervision is necessary when any appliance is used by or near
children
•
Make sure the appliance is turned OFF when not in use, before changing
accessories or cleaning
•
Do not remove the lid or place your hands near moving parts when the
appliance is operating
•
Do not attempt to operate an attachment if it has been dropped or damaged
in any way. Contact your local distributor for repair or replacement
•
Do not attempt to use parts or attachments not approved for use by
the manufacturer. Use of attachments not recommended or sold by the
manufacturer may cause fire, electric shock or injury
•
Keep hands, hair and clothing well away from moving parts
•
Always remove accessories from the power base before cleaning
•
Never feed food into accessories by hand when operating; always turn off
the appliance before removing the lid
•
Flashing light indicates ready to operate. Avoid any contact with blades or
moveable parts
• Do not expose to rain or use in wet condition
• If an extension cord is used, the instructions concerning the proper cord as
contained on pg. 15 should be followed
• Connect to a grounded type receptacle or use with an acceptable adapter
see pg. 15 for further directions
•
SAVE THESE INSTRUCTIONS
Contact Information
For service, ordering or if you have questions about the installation or operation
of your food center, contact your local distributor or:
Kitchen Center by TCC, LLC
315 West La Cadena, Riverside, CA 92501
Tel: 888-822-5824
www.TCCkitchencenter.com
To attach to the power base,
insert the mini-chopper power
post into the power base, push
down and turn clockwise until
snug.
Always disassemble the
mini-chopper to clean it. The
blades, cap and lid can be
placed into your dishwasher.
The power post should be
carefully washed and dried by
hand.
CAUTION
Keep hands and utensils away from the cutting blades while chopping food
reduce the risk of severe injury to persons or damage to the mini- chopper. A
scraper may be used but only when the mini-chopper is not running.
Blades are sharp. Handle carefully. To reduce the risk of injury, never place the
cutting blades on the base without first putting the bowl properly in place.
Make certain the cover is securely locked in place before operating the mini-
chopper.
Do not attempt to defeat the cover locking mechanism
.