TCC Kitchen Center Installation Manual - page 6
4
9
Installation
Positioning the template
Position the template as shown below and draw a line around it.
and indoor use when used with the Kitchen Center Power Base
The Blender attachment has been approved for both outdoor
• At least 1” back from the inside edge of the base cabinet beneath the
countertop
• Keep at least 4” from any adjacent walls
• Allow at least 18” clearance between the countertop and any
overhanging cabinets
• Allow for a minimum depth of 8” beneath the bottom of the counter to
accommodate the Power Base
Note
A 15A/125V AC outlet must be pre-wired beneath the chosen location prior to
installation.
CAUTION
All electrical wiring must comply with local electrical codes.
Attachments
The attachments for the Kitchen Center
replace many small appliances. For more
options, visit www.TCCkitchencenter.com
The Blender
You can order the blender in glass or stainless
steel. Move smoothly through the five speeds on
the keypad or use the pulse key for a short burst
of power.
To assemble the blender:
1. Place the blades and gasket into the
blender base.
2. Attach the jar by turning clockwise until
snug.
3. Press the two part lid onto the jar.
To attach to the Power Base, place the blender
into the power base and turn clockwise until fully
seated
CAUTION
Do not run continuously for more than 3 minutes at a time.
Keep hands and utensils out of the blender jar when in use to reduce the
risk of severe injury to persons or damage to the blender. A scraper may be
used but only when the blender is not running.
Blades are sharp. Handle carefully. Always operate the blender with the
cover in place. When blending hot liquids, remove the centerpiece of the
two piece cover
The blender has an integral stable
base which allows you to stand it
on the counter. It is easily cleaned
in your dish washer. The plastic
base and the gasket should
be placed on the top shelf. Dry
thoroughly before use or storage.
Inside edge of counter top