- DL manuals
- U-Line
- Refrigerator
- CLR2160
- Install Manual
U-Line CLR2160 Install Manual
Summary of CLR2160
Page 1
? the built-in undercounter leader since 1962 clear ice models clear ice combo models ice combo models u-line.Com co1175 co2175 clr2160 clrco2175 install guide co29.
Page 2
Safety precautions safety alert definitions.........................................................................................................................................1 general precautions .....................................................................................................
Page 3
U-line safety precautions 1 important important • please read all instructions before installing, operating, or servicing the appliance. • proper installation procedures must be followed when completing an installation or relocation of a unit. Consult the installation guide before any installation b...
Page 4
U-line inspect & plan 2 3 inspect & plan product registration you have received a carton containing your u-line clear ice, ice or ice combo unit with a package inside containing a use and care guide, a product registration card, and a water line kit. Please complete and mail the product registration...
Page 5
Prepare site 3 4 prepare site your u-line product has been designed for either free-standing or built-in installation. When built-in, your unit does not require additional air space for top, sides, or rear. However, the front grille must not be obstructed and clearance is required for an electrical ...
Page 6
Product dimensions 4 5 product dimensions clr2160 series co1175 series co29 series 23” * 28-1/2" 20-13/16" *add 15/16” to depth for water line clearance 4-3/4” 34-3/16" 24" black and white stainless steel 34-3/16" 24” 3-13/16” 3-13/16” 23-1/16”* 23-1/16”* *add 3/4” to depth for water line clearance ...
Page 7
Door swing dimensions 5 6 door swing dimensions all units have a zero clearance for the door to open 90°. U-line recommends a minimum door clearance of 2” to accommodate the handle if the unit is installed next to a wall. Other site requirements side-by-side installation for a complete refreshment c...
Page 8
U-line standrd door alignment and reversal 6 7 standard doors door alignment and adjustment align and adjust the door if it is not level, or is not sealing properly. If the door is not sealed the unit may not cool properly, or excessive frost may form in the interior. Important important properly al...
Page 9
U-line standrd door alignment and reversal 7 install bottom hinge: 1. If you have a plate hinge, reorient the pivot screw so it protrudes the opposite direction form the hinge. Remove the pivot screw from the hinge. Turn the plate over and reinstall the screw. 2. Align hinge outer edge with cabinet....
Page 10
U-line self-closing door alignment and reversal 8 1/8" (3.175 mm) 1 2 3 4 8 self-closing doors door alignment and adjustment align and adjust the door if it is not level, or is not sealing properly. If the door is not sealed the unit may not cool properly, or excessive frost may form in the interior...
Page 11
U-line self-closing door alignment and reversal 9 3 4 uli 5 notch 1 2 to reverse the door: remove door: 1. Hold door to keep it from falling. 2. Remove hinge screw pin (1) from top hinge using a phillips screwdriver. 3. Remove door by tilting forward and lifting door off bottom hinge closer inserts....
Page 12
U-line door panel installationl 10 9 door panel installation custom 1/4'' thick door panel insert door panel preparation a custom door panel may be inserted into the doorframe. Custom door panels can be flat or raised, as long as the maximum panel thickness, where inserted into the door reveal (chan...
Page 13
U-line electrical / plumbing specfications 11 10 prepare power supply electrical specifications warning shock hazard — electrical grounding required. • never remove the round grounding prong from the plug and never use a two-prong grounding adapter. • never use an extension cord to connect power to ...
Page 14
U-line electrical / plumbing specfications 12 p caution plumbing installation must observe all state and local codes. All water and drain connections must be made by a licensed/qualified plumbing contractor. Failure to follow recommendations and instructions may result in damage and/or harm. Water s...
Page 15
U-line electrical / plumbing specfications 13 factory-installed drain pump if your drain line will run up to a stand pipe, disposal or spigot assembly, or does not otherwise meet the requirements for a gravity drain, you may have ordered the clr2160 or clrco2175 with a u-line p60 drain pump. See bel...
Page 16
U-line electrical / plumbing specfications 14 to connect to drain: warning to prevent accidental electrocution, make certain that the floor surfaces surrounding the unit are dry whenever power is removed from, or applied to, the unit. 1. Slide 2 hose clamps onto the drain connection on the rear of t...
Page 17
Level & install unit 15 12 level the unit leveling information it is recommended that the unit is level. 1. Use a level to check the levelness of the unit from front to back and from side to side. Level should be placed along top edge and side edge as shown 2. If the unit is not level, adjust the fe...
Page 18
Level & install unit 16 installation troubleshooting problem q: water is leaking under the unit. Solution a: a water leak under the unit is most likely caused by a bad connection in the water supply line. Make sure the water line’s brass fitting is screwed tight to its valve and threaded correctly. ...
Page 19: Installation Guide
? about u-line building on 45 years, u-line has captivated those with an appreciation for the finer things with exceptional design, inspired innovations and attention to even the smallest details. U-line is synonymous with premium built-in undercounter ice making, refrigeration and wine storage appl...