1. DL manuals
  2. U-Line
  3. Refrigerator
  4. CLR2160
  5. Use And Care Manual

U-Line CLR2160 Use And Care Manual

Manual is about: ÉCHELON MODELS ORIGINS MODELS

Summary of CLR2160

  • Page 1

    Use and care guide clr2160 clrco2175 clear ice maker model: clr2160 clear combo ® ice maker/refrigerator model: clrco2175 ulin_30096_5-7-07.Fm page 1 friday, may 11, 2007 11:06 am.

  • Page 2

    2 clr2160, clrco2175 congratulations on your purchase of a u-line refrigeration product. A pioneer in the field for more than 40 years, u-line corporation is the world’s number one manufacturer of built-in, under-counter, specialty refrigeration and ice making products. U-line dedicates 100% of its ...

  • Page 3

    Clr2160, clrco2175 3 introduction ...............................................................................................................................2 warranty registration .......................................................................................................2 please rec...

  • Page 4

    4 clr2160, clrco2175 this page intentionally left blank ulin_30096_5-7-07.Fm page 4 friday, may 11, 2007 11:06 am.

  • Page 5

    Clr2160, clrco2175 5 important important please read all instructions completely before attempting to install, operate, or service your unit. • proper installation procedures must be followed if this unit is being initially installed, or is moved to a new location after being in service. An installa...

  • Page 6

    6 clr2160, clrco2175 Échelon model clr2160 clear ice maker, model clrco2175 clear ice maker/refrigerator clr2160 • this model produces up to 60 lbs (27.2 kg) of ice per day, will store 30 lbs (13.6 kg). • stainless steel model is deemed suitable for outdoor use by ul. • an electronic control panel w...

  • Page 7

    Clr2160, clrco2175 7 figure 2 important important proper air flow (figure 2) is required for your unit to operate at its highest efficiently. A grille, located in the base of the unit, must not be blocked at any time, or your unit will not perform as expected. Initial startup all u-line units are sh...

  • Page 8

    8 clr2160, clrco2175 temperature control checking product temperature figure 4 to check the actual product temperature, in refrigerator section only, insert an accurate thermometer into a plastic (non-breakable) bottle that is partially filled with water. Tighten the bottle cap securely (figure 4). ...

  • Page 9

    Clr2160, clrco2175 9 temperature display to display the model clrco2175 interior temperature: 1. Touch and hold the warmer icon (figure 5, 2) for approximately five seconds and release when the °f symbol in the display (figure 5, 3) begins to flash. 2. The display (figure 5, 3) will indicate the act...

  • Page 10

    10 clr2160, clrco2175 storage, vacation, moving if the unit will not be used for an extended period, or otherwise stored, follow these steps completely: warning electrical shock hazard. Disconnect power before servicing. Before operating, replace all panels. Failure to do so may result in death or e...

  • Page 11

    Clr2160, clrco2175 11 general cleaning exterior cleaning (as required) black and white models: • surfaces may be cleaned with a mild detergent and warm water solution. Do not use solvent-based or abrasive cleaners. Use a soft sponge and rinse with clean water. Wipe with a soft, clean towel to preven...

  • Page 12

    12 clr2160, clrco2175 to defrost: 1. Turn unit off. 2. Remove all products from the interior and prop the door in an open position (2 in. (5 cm) minimum). 3. Allow the frost to completely melt naturally. Clean the interior and all removed components using a mild non- abrasive detergent and warm wate...

  • Page 13

    Clr2160, clrco2175 13 figure 9 1. Turn the ice maker off (allowing any ice to melt off of the evaporator) as follows: a. Touch and hold the on/off button (figure 9, 1). B. The display (figure 9, 3) will switch from ice to off to confirm that the ice maker is off. 2. Remove all ice from the storage b...

  • Page 14

    14 clr2160, clrco2175 figure 12 4. Disconnect the hose connector (figure 12, 1) from the water solenoid valve (figure 12, 2). 5. Do not remove the inlet screen (figure 12, 3) from the water solenoid valve. Use a toothbrush to gently clean any sediment from the inlet screen. 6. Re-connect the water s...

  • Page 15

    Clr2160, clrco2175 15 figure 15 a unit that is not level can cause a reduction in ice rate, uneven sized cubes or water spilling into the storage area, which will cause the ice in the bin to melt prematurely (figure 15). When checking the level, remember that floors near drains have a tendency to sl...

  • Page 16

    16 clr2160, clrco2175 figure 20 3. Turn the door upside down and inspect the hinge plate mounting holes. • your plate has slotted mounting holes (figure 20, 1). Loosen but do not remove the two hinge plate screws. 4. If door edge opposite the hinges needs to move up, move plate toward outside of doo...

  • Page 17

    Clr2160, clrco2175 17 figure 24 2. Remove plastic screw plugs (three each, top and bottom) (figure 24, 1) from new hinge location. Do not discard. 3. Remove top hinge (three screws) (figure 23, 2) and reinstall hinge screw pin (figure 23, 1). Figure 25 4. Install the removed top hinge mount on oppos...

  • Page 18

    18 clr2160, clrco2175 to install the door shelf: 1. Holding shelf in center, align notches (figure 28, 1) in shelf with bosses (figure 28, 2) in door. 2. Tilt shelf at a 15°-20° angle and slide onto bosses at the desired location. Glass shelf removal/installation figure 29 1. Pull shelf out about 6"...

  • Page 19

    Clr2160, clrco2175 19 figure 30 2. Locate the u-line supplied garden hose fitting. Ensure the end of the copper tubing has been cut straight and free of burrs. Slide the compression nut and ferrule onto the copper tubing as shown (see figure 31). Push the assembly completely into the the garden hose...

  • Page 20

    20 clr2160, clrco2175 if using a gravity drain: 1. Slide 2 hose clamps onto the drain connection on the rear of the appliance. 2. Insert the barbed fitting halfway into this connection. 3. On the other end of this barbed fitting attach the 5/8” braided tubing. 4. Slide a clamp on each side of the ba...

  • Page 21

    Clr2160, clrco2175 21 4. Check that the clamps and hose connections are tight at the following areas (see figure 36): • discharge tube (a) • drain tube (b) • vent tube (c) figure 36 5. Place a suitable container beneath the pump’s discharge tube. (the bucket must be able to hold a minimum of one gal...

  • Page 22

    22 clr2160, clrco2175 figure 39 warning to prevent accidental electrocution, make certain that the floor surfaces surrounding the unit are dry whenever power is removed from, or applied to, the unit. Figure 40 to connect to drain: 1. Slide 2 hose clamps onto the drain connection on the rear of the a...

  • Page 23

    Clr2160, clrco2175 23 9. After unit is in its final position, finish routing drain tube to the desired location. Common installations use a floor drain, standpipe, garbage disposal, or y-branch tailpiece type drain connection (see figures 37, 38 and 39). 10. Check to ensure unit is level both side t...

  • Page 24

    24 clr2160, clrco2175 before calling for service if your u-line product appears to be malfunctioning, read through the operation section of this guide to ensure that the function of all controls are clearly understood. If the malfunction persists, the troubleshooting guide in this guide will assist ...

  • Page 25

    Clr2160, clrco2175 25 troubleshooting guide danger electrocution hazard never attempt to repair or perform maintenance on the unit until the main electrical power has been disconnected. Note: recommended refrigerator temperature setting is 38°f. Troubleshooting - what to check when problems occur: p...

  • Page 26

    26 clr2160, clrco2175 unit runs but produces very little ice. Dirty condenser coils clean the condenser (see maintenance; condenser cleaning). High air temperature around unit surrounding air temperature of over 90°f. Low ice production at high temperatures is normal. Scale and mineral buildup in un...

  • Page 27

    Clr2160, clrco2175 27 electronic control quick guide note: 38°f is an example; the display will vary with actual set-point. Important factory recommended set-point is 38°f for refrigerators and beverage centers, and 50°f for wine coolers. All models task touch touch display comment turn on/off hold ...

  • Page 28

    28 clr2160, clrco2175 u-line corporation limited warranty u-line corporation warrants each u-line product to be free from defects in materials and workmanship for a period of one year from the date of purchase; and warrants the sealed system (consisting of the compressor, the condenser, the evaporat...

  • Page 29

    Clr2160, clrco2175 29 this page intentionally left blank ulin_30096_5-7-07.Fm page 29 friday, may 11, 2007 11:06 am.

  • Page 30

    30 clr2160, clrco2175 this page intentionally left blank ulin_30096_5-7-07.Fm page 30 friday, may 11, 2007 11:06 am.

  • Page 31

    Clr2160, clrco2175 31 this page intentionally left blank ulin_30096_5-7-07.Fm page 31 friday, may 11, 2007 11:06 am.

  • Page 32

    For general inquiries: p.O. Box 245040 milwaukee, wisconsin 53224-9540 u.S.A. Phone (800) 779-2547 fax (414) 354-5696 www.U-line.Com for service and parts assistance: phone (800) 779-2547 (414) 354-0300 fax (414) 354-5696 email: onlineservice@u-line.Com www.U-lineservice.Com e-mail: onlineparts@u-li...