Vac Pro ALI-VAC1 Installation & Operating Instructions Manual - page 20
18
INSTALLATION AND OPERATING INSTRUCTIONS
TROUBLE SHOOTING
BEFORE YOU CALL FOR SERVICE PLEASE REVIEW THE TROUBLE SHOOTING TIPS FIRST.
Problem
Possible Cause
Solution
Nothing happens when I
press the vacuum sealer
1. Power cord not plugged in.
2. Power cord is damaged.
1. Make sure the power cord is correctly plugged into the electrical
outlet, and in the “on” position.
2. Check power cord and plug, and make sure they are not damaged
in any way. If damaged, do not use the vacuum sealer.
Air is not removed from the
bag completely
1. The bag has not been
placed correctly inside
the Removable Vacuum
Chamber.
2. Debris covering sealing strip
or gasket. Sealing strip or
gaskets may be out of place.
3. Bag may have a hole.
4. Unit cover has not been
closed properly.
1. To seal properly, open end of bag should be resting entirely inside
the Removable Vacuum Chamber.
2. Check sealing strip and gasket beneath the lid for debris and wipe
clean and smooth them back into place.
3. To test, seal the bag with some air in it, submerge in water, and
apply pressure. If there are bubbles present, it does indicate a leak
and a new bag should be used.
4. Open cover and reclose cover ensuring two clicks are heard to
ensure cover is closed completely.