Vac Pro ALI-VAC1 Installation & Operating Instructions Manual - page 7
INSTALLATION AND OPERATING INSTRUCTIONS 5
Note: Operate unit on a stable level flat surface, keep away from
moving parts. Ensure surface is clean and free from water. Do not
place the unit near the edge of a bench or table during operation.
Note: If unit has been in storage with cover locked in place, before
operation of the unit allow the lower gasket (which would have
been compressed over time while in storage) to decompress back
into shape.
1. Fully unwind the power cord and connect to a 230V/240V
power outlet.
2. Place preferred bag roll size into the Roll Storage Compartment
and secure the Roll Storage Compartment to the back of the
Vacuum Seal Unit.
3. Open the cover of unit by pressing the left and right Cover
Release Buttons simultaneously.
4. Thread bag from Roll Storage
Compartment through bottom
opening of cover (see Fig 1).
5. Pull out bag to desired length.
Note: You will require at least 3
inches of bag material more than
the item as this extra part will
form the seal.
6. Release Roll Cutter from underneath the cover by pressing the
left and right Roll Cutter Release Buttons simultaneously
(see Fig 2).
7. Slide Roll Cutter incision button from one side to the other to
cut the bag to length (see Fig 3).
8. To seal 1 end of the bag place an end over the Sealing Profile
and close cover so that two clicks can be heard to ensure
cover is fully closed.
Fig 2
Fig 3
B. Preserving Food in Vacuum Bags
Fig 1
incision button