VAG-Navisystems NaviTouch Installation manual - page 19
3. GPS Box configuration - System configuration:
3.1. Calibrating touch and adjusting the image:
When starting the vehicle, it will appear on its screen, the OEM original
menu image:
Don’t insert the SD Card map yet,
Push briefly the NAV button of
the steering wheel for 2 sec. to enter NAVI mode, Screen’s image will
change and it’s going to show NAVI mode (GPS Box) image, wait some
seconds, until appears calibration image:
Push this cursor “+” on the touch screen, once pushed the + cursor,
it will change its position, push it in every zone of the screen where it
appears until you receive “OK” message, at this way you will have cali-
brated successfully the touch screen gps function, if it doesn’t appears
“OK” message, you must repeat this process again. Once you have
done the calibration process it will appear this message “Unable to find
navigation software”, push on this message to omit it.
Then you must config. the multimedia interface, push the Menu but-
ton of the multimedia interface’s remote control to enter to the basic
settings menu, use or of the remote control to move to OSD
and push OK, now push OK on LANGUAGE, useor buttons of the
remote control to select the English language, and push OK to confirm
your selection, then push the Menu button of the remote control until
the basic settings menu disappears.
Now, push the
◄ button for 5 seconds to enter to the interface advan-
ced settings menu or push the following button combination:
▲→ ▼→ ▲→ MENU.
Move the selector to UTIL, using
▲ or ▼ buttons of the remote con-
trol and push OK, push OK again on TOUCH CALIBRATION, select YES
option by the
▲ or ▼ remote control buttons and push OK.
19