VAG-Navisystems NaviTouch Installation manual - 3.2. Reset:
Even if you do this changes and you can’t adjust the image as
much as you want, you can use the multimedia interface image
setting menu.
Now push the
◄ button of the multimedia interface remote
control for 2 seconds to enter to the advanced settings menu,
this image will be shown:
Use
▲ or ▼ buttons of the remote control to select IMAGE in
the menu, and push OK to enter. Now use
▲ or ▼ buttons of
the remote control to select between the H-POSITION (Hori-
zontal position) and V-POSITION (Vertical position), once you
have entered to one of the options, adjust it by using the
▲ or
▼ buttons of the remote control, push OK to confirm.
3.2. RESET:
3.3. Maps SD card and GPS signal:
21
If you RESET the GPS Box or the multimedia interface, repeat again the steps from the chapter 3.1, may-
be, when you perform a RESET on it, the language of the GPS Box could be changed, follow the next steps
to config. it again to your desired language:
Make a touch calibration of the GPS Box following the steps described before, now push the “Settings”
button, then push the “Usual Setup” button and select the language that you prefer.
NOTE: If you change the position of the
RGB to AV Switch from the GPS Box
(in
RGB
default position) it
will RESET, then follow the steps described before to adjust the system again.
Once you have insert the Maps SD card, we have to setup the route of the executable file (.exe), follow
the next steps:
Push on Settings, then in Navigate Setup, uncheck the auto initialitzation software option, and push on
the folder icon.